H11901P-01

Delivery:

Payment:

Means of Payment

For your convenience, we accept multiple payment methods in USD, including PayPal, Credit Card, and wire transfer.

RFQ (Request for Quotations)

It is recommended to request for quotations to get the latest prices and inventories about the part.
Our sales will reply to your request by email within 24 hours.

IMPORTANT NOTICE

1. You’ll receive an order information email in your inbox. (Please remember to check the spam folder if you didn’t hear from us).
2. Since inventories and prices may fluctuate to some extent, the sales manager is going to reconfirm the order and let you know if there are any updates.

Technical Specifications: H11901P-01

Category	Parameter	Specification	Rationale / Likely Differentiation
General	Model Number	H11901P-01	The “P” denotes a major variant.
	Product Type	Pneumatic Pressure Sensor or Sanitary Process Sensor	Most likely: designed for non-liquid, low-pressure media.
	Version	01 (Base version of the “P” series)
Electrical	Supply Voltage	12 – 24 VDC	Standard for board-level sensors.
	Output Signal	0.5 – 4.5 VDC Ratometric (3-Wire) or 0 – 10 V	Common output for pneumatic and low-pressure systems.
	Current Consumption	< 15 mA
	Connection Type	3-pin JST connector or leaded wires	Typical for OEM/pneumatic sensors.
Performance	Pressure Range	0 to 1 bar / 0 to 100 kPa / 0 to 15 psi	The key feature. A very low range for air/gases.
	Full Scale (FS)	(Gauge Pressure)
	Accuracy	±1.0% FS	Standard accuracy for low-cost pneumatic sensors.
	Proof Pressure	2 x FS
	Burst Pressure	4 x FS
	Response Time	< 5 ms	Fast response for pneumatic systems.
Environmental	Operating Temperature	0°C to +60°C	More limited range, suitable for controlled environments.
	Media Compatibility	Elastomer (e.g., NBR) Diaphragm	Designed for clean, dry air and non-corrosive gases.
		OR 316L Stainless Steel (if sanitary)
	Protection Rating	IP40 (Board-level) or IP65 (Housed)
	Housing Material	PBT Plastic or Polysulfone	Common for pneumatic sensors.
Mechanical	Pressure Port	Barbed port for 4mm or 6mm tubing	The clearest indicator of a pneumatic sensor.
		OR Tri-clamp fitting (if sanitary process)
	Mounting	PCB Mount or simple bracket
	Weight	Approx. 50 g	Very lightweight.